Team Xray T3 2012 - Ca' de Mandorli - Set-up di partenza per condizioni di grip medio-alto.
Front End
| Parameter | Value |
|---|---|
| Ackermann position | 1 mm |
| Anti Roll Bar | 1.4mm |
| Arm flex | Graphite |
| Bumpsteer Washer | 4 mm |
| Camber | 2 ° |
| Camber link inside height | 0 mm |
| Camber link inside location | 1 (Outside) |
| Camber link outside height | 1 mm |
| Caster Block | 4° |
| Caster block type | Hard |
| Downstop | 6 mm |
| Drive shaft length | 52mm |
| O-ring on shock shaft | Yes |
| Ride Height | 5 mm |
| Rollcenter FF | -0.75 |
| Rollcenter FR | -0.75 |
| Shim under shock | 0.5 mm |
| Shock foam insert | No |
| Shock length | - mm |
| Shock mounting lower | Standard |
| Shock mounting upper | 3 |
| Shock oil | 350 cSt |
| Shock piston | 3 |
| Shock Preload | - mm |
| Shock Rebound | - % |
| Shock spring | 2.4 |
| Spacer FF | 1 mm |
| Spacer FR | 1 mm |
| Steering block | Hard |
| Toe | -1 ° |
| Wheelbase | 0 |
Rear End
| Parameter | Value |
|---|---|
| Anti Roll Bar Rear | 1.2mm |
| Anti-roll bar position | 2 |
| Arm flex | Standard |
| Camber | 2 ° |
| Camber link inside location | 0 mm |
| Camber link inside location | 2 |
| Camber link outside height | 3 mm |
| Camber link outside location | 1 (Inside) |
| Downstop | 5 mm |
| Drive shaft length | 50mm |
| Hub type | Hard |
| Inboard toe shim RF | 0 mm |
| Inboard toe shim RR | 1.2 mm |
| O-ring on shock shaft | Not selected |
| Outboard toe | +2.0 ° |
| Ride Height | 5 mm |
| Rollcenter RF | 0.00 |
| Rollcenter RR | 0.00 |
| Shim RF | 0 mm |
| Shim RR | 1.2 mm |
| Shim under shock | 0.5 mm |
| Shock foam insert | No |
| Shock length | - mm |
| Shock mounting lower | Standard |
| Shock mounting upper | 3 |
| Shock oil | 400 cSt |
| Shock piston | 2 |
| Shock rebound | - % |
| Shock spring | 2.8 |
| Wheelbase | 0 |
Chassis
| Parameter | Value |
|---|---|
| Additional weights | N/A |
| Bodyshell | Mon-Tech Nazda2 |
| Car weight | 1473 g |
| Diff position (front) | Up |
| Diff position (rear) | Up |
| Lower suspension block | Single 2pcs |
| Lower suspension block (front) | Solid 1pcs |
| Wing type | Ultracharge 1.00mm |
Drivetrain
| Parameter | Value |
|---|---|
| Front diff setting | N/A |
| Front differential type | Solid Axle |
| Pinion | 43 Tooth |
| Rear diff setting | 2000 cSt |
| Rear differential type | Gear |
| Spur gear | 96 Tooth |
Electronics
| Parameter | Value |
|---|---|
| Batteries | LRP 7200 |
| Brake e.p.a | 100 % |
| Brake expo | 0 % |
| ESC | LRP Flow WorksTeam |
| ESC setting | 5.4 Stock Firmware |
| Motor | LRP x20 13.5 |
| Motor timing | 30 invertito ° |
| Radio | Sanwa MX-3X |
| Servo | Savox 1252 |
| steering e.p.a | 100 % |
| Steering expo | -15 % |
| Throttle e.p.a | 100 % |
| Throttle expo | +/- 0 % |
General
| Parameter | Value |
|---|---|
| Setup Notes | Preadditivo pulitore WRC, additivo X-Grip Strong o Rheinard. |