Team Associated RC10B6.1 - 2019 WJ-I Hakkila -
Front End
| Parameter | Value |
|---|---|
| Anti Roll Bar | None |
| Arm flex | Hard |
| Arm type | Flat |
| Axle height | 0 |
| Bulkhead type | std |
| Bumpsteer Washer | 2 mm |
| Camber | -1 ° |
| Camber link inside height | 0 mm |
| Camber link inside location | Outside |
| Camber link outside location | Inside |
| Caster Block insert | 5° |
| Caster Block Spacing | 1 mm |
| Eyelet length | Short |
| Kick-Up angle | 25° |
| Ride Height | 19 mm |
| Shock cup offset | 5mm |
| Shock limiter | 1 mm |
| Shock mounting lower | Middle |
| Shock mounting upper | Outside |
| Shock oil | 40 |
| Shock piston | 2x1.6 Flat |
| Shock Spring | AE Red V2 |
| Shock stroke | 21.7 mm |
| Shock tower | Flat |
| Steering block | 4 mm |
| Steering Rack Spacers | 0 mm |
| Steering Stop Spacing: | mm |
| Toe in | 1 ° |
| Wheel hex | 5.0 mm |
Rear End
| Parameter | Value |
|---|---|
| Arm flex | Standard |
| Block C insert position | Upper outside |
| Block C insert type | 0.5° |
| Block C type | Standard |
| Block D insert position | Lower outside |
| Block D insert type | 0.5° |
| Block D type | Standard |
| Camber | -1 ° |
| Camber link inside height | 0 mm |
| Camber link inside location | Middle |
| Camber link outside height | up mm |
| Camber link outside location | E |
| Differential Height | 0 |
| Drive shaft length | 65mm |
| Eyelet length | Long |
| Hub insert | +1mm |
| Hub Spacing | Back |
| Hub type | Not selected |
| Rear hex width | mm |
| Ride Height | 19 mm |
| Shock cup offset | 5mm |
| Shock limiter | 0 mm |
| Shock mounting lower | A |
| Shock Mounting Position | Front of arm |
| Shock mounting upper | Inside |
| Shock oil | AE 30 |
| Shock piston | 2x1.8 Flat |
| Shock Spring | AE White |
| Shock stroke | 28 |
| Shock tower | Standard |
Chassis
| Parameter | Value |
|---|---|
| Battery placement | F5 mm |
| Bodyshell | |
| Car weight | 1515 g |
| Chassis weights | 26g ballasti |
| Front wing | JC Wide |
| Rear Wing | |
| Side Rails type | Standard |
| Transmission type | 3 Gear Lay Down |
| Wing angle | 0 |
Drivetrain
| Parameter | Value |
|---|---|
| Diff setting Rear | 1000 |
| Final Drive Ratio | |
| Internal Gear Ratio | |
| Pinion | 22 Tooth |
| Rear differential type | Gear |
| Slipper | V2 |
| Slipper notes | |
| Slipper pads | 2 pads |
| Slipper setting | mm |
| Spur gear | 75 Tooth |
Electronics
| Parameter | Value |
|---|---|
| Batteries | Performa P1 PA9307 |
| Brake EPA | 85% % |
| Brake expo | 100 % |
| ESC | |
| ESC setting | Ennakot 0 |
| Motor | Reedy sonic mach 3 6.5 |
| Motor timing | 20 ° |
| Radio | Sanwa MT4S |
| Servo | Savöx SC-1257TG |
| Steering EPA left | % |
| Steering EPA right | % |
| Steering expo | % |
| Throttle expo | 90 % |
General
| Parameter | Value |
|---|---|
| Setup Notes | Takaiskarin yläpäässä 2mm shimmiä. |